GPS_INSTALL

TomTom Rider 2

This GPS has been discontinued.

I used alcohol to clean the surfaces prior to
installing the velcro tabs in two locations
in the speaker opening.

Velcro strip rolled to hold the power cord.

Power cord held in place by rolled velcro
strip attached to velcro tab. Tab is
self-adhesive.

Looking into the speaker opening.

Looking into the speaker opening.

Looking into the speaker opening. Look carefully
and you will see the second velcro strip and tab
I installed to keep the power cord in place
in the speaker opening.

GPS power cord attached to the power connector
for the FUEL gauge.

I now plugged the connectors for the FUEL gauge
and the TEMPERATURE gauge back into place.

Bolted the dash back into place using the 4 screws.

Snapped the speaker cover into place.

JOB DONE !!

GPS powers up when I turn on the ignition.
Powers down when I turn the ignition off.

Previous Home
2 of 2

1 2

I used alcohol to clean the surfaces prior to installing the velcro tabs in two locations in the speaker opening.	Velcro strip rolled to hold the power cord.
Power cord held in place by rolled velcro strip attached to velcro tab. Tab is self-adhesive.	Looking into the speaker opening.
Looking into the speaker opening.	Looking into the speaker opening. Look carefully and you will see the second velcro strip and tab I installed to keep the power cord in place in the speaker opening.
GPS power cord attached to the power connector for the FUEL gauge.	I now plugged the connectors for the FUEL gauge and the TEMPERATURE gauge back into place. Bolted the dash back into place using the 4 screws. Snapped the speaker cover into place. JOB DONE !! GPS powers up when I turn on the ignition. Powers down when I turn the ignition off.